开云体育

Hi John I will email you off list.... 73 Hans G0UPL http://qrp-labs.com https://buymeacoffee.com/g0upl [email protected]> wrote:

Not useful at all for this application. First he has 37dbm (5W) already from the HL2.? So there is no step up there as 24.7 DBM is 350mW and 7 W (using RD15) is still short of the 10W desired. Plus

I need help to complete and pay for my qnx. KB7HNF As soon as.I get a bill I will get with my bank and send.you a bank transfer. [email protected]> wrote:

Thank you Russ! I assume yor receive is working well? If so, what other areas could I check to see why I have such a high noise floor?

And here is another solution from EU1SW. Costly but offers 14-bit, 6m and 160m and power to run your amp to full output: https://www.ebay.com/itm/256147932051 -- John AE5X https://ae5x.blogspot.com

Timmy, Your not paying attention. Refresh yourself with /g/QRPLabs/message/125855 He has a nice BLA-350 that with his 5W gives him 130W. It needs 10W for full power (greater than

I also have a fair amount of noise on the I/Q diagnostic. Also, the levels (35269) are different than what I've seen in the manual and posted here. But operationally, I have good sensitivity on all

Hi Sam The messages are already retained in memory when the firmware is updated... In general firmware updates don't alrer the settings. They're only erased by a factory reset. Occasionally when I

Joe, I haven’t experienced this problem using a straight key. However, something similar occurs with a paddle and Iambic B with autospace turned on. Maybe autospace? Steve

Bruce, The PCM1804 is likely bad. That chip has been exhibiting a very wide range of failure symptoms in QMX, from subtle and noise related to complete meltdown. Yours appears to be a case of damage

If I understand you correctly, you're looking for the WSPR freqs for each band. Page 35 of the QMX operating manual lists them--or did you already know that? In any event I usually aim for a frequency

Great job. Mike Krieger [email protected]> wrote:

Thanks Karl. You are running the QMX via wjst ?

Mine displays the freq that WSJT-X puts in for the band selected. -- 73 Karl KI4ZUQ

Hans, I don't know if this is a possibility with the firmware / hardware configuration, but... Is it possible that the messages programmed in are able to remain within the eprom when firmware is

Can anyone tell me the SCREEN DISPLAYED frequency by band for the QMX please when used in WSPR? yes I’ve googled it, yes I’ve done all that stuff. I just want to hear what others think. I’m

It is possible but I have quite a few different sized micro bits so use just the size necessary for the part to fit through leaving most of the via intact. It’s just an option and another way to

I have a different version but they all have a 1/8” plug in for wired connection. Be the REASON someone smiles today. Dave K8WPE

Thanks Hans, for adding the links :-) Small update on my QMX+. Like all the cases from QRP-Labs, I really love the QCX+ / QMX+ case. But when you the have QCX+ or QMX+ case it on a desk, the

Hi Peter It might be worth looking at the BLA-350 circuit diagram, there maybe an attenuator before the amplifier stage. This is certainly the case with the Yaesu FL-110 100w amp which according to