开云体育

Great job. Mike Krieger [email protected]> wrote:

Thanks Karl. You are running the QMX via wjst ?

Mine displays the freq that WSJT-X puts in for the band selected. -- 73 Karl KI4ZUQ

Hans, I don't know if this is a possibility with the firmware / hardware configuration, but... Is it possible that the messages programmed in are able to remain within the eprom when firmware is

Can anyone tell me the SCREEN DISPLAYED frequency by band for the QMX please when used in WSPR? yes I’ve googled it, yes I’ve done all that stuff. I just want to hear what others think. I’m

It is possible but I have quite a few different sized micro bits so use just the size necessary for the part to fit through leaving most of the via intact. It’s just an option and another way to

I have a different version but they all have a 1/8” plug in for wired connection. Be the REASON someone smiles today. Dave K8WPE

Thanks Hans, for adding the links :-) Small update on my QMX+. Like all the cases from QRP-Labs, I really love the QCX+ / QMX+ case. But when you the have QCX+ or QMX+ case it on a desk, the

Hi Peter It might be worth looking at the BLA-350 circuit diagram, there maybe an attenuator before the amplifier stage. This is certainly the case with the Yaesu FL-110 100w amp which according to

I installed a miniature toggle switch in the rear panel replacing the power jumper on the board. Maybe a better solution will come in the future. For now I can turn off the noise when not using the

Thank you for the suggestions. I removed R306 and replaced with a 1/8 watt 900 ohm resistor. On either side of the SMA R306 is a large pad making it easy to solder in a larger resistor. Thank you

Peter , before you jump in the company 60dbm.com out of Ukraine but still working has some nice solutions specifically set up for the machines like Hermes Light and even lower power Qrp transmitters .

Linear Tech's AD8009 highspec VIdeo amp is your friend here - costs about 5 Benjamins each from Chicom dealers . THese have been successfully used as driversfor RD 15HH Mosfets in class A to get 7 W

Ahoy there mon !! as Bob Marley would say .. we are sitting here holding our breath waiting for the story that it was a bad solder joint or a plated through hole (ie PTH that take signals from bottom

So I am making a second post. I recently assembled a QMX. Fired up at 7v limited to 200ma. Loaded the firmware. The transmit on all band is great with 4 to 5w. This is a 60 to 15m model. The problem

How does one use this? It seems to be Bluetooth only. -- Wayne S. KF7RCM

https://www.amazon.com/Bluetooth-Speakers-Bluetooth-Wireless-Portable-Shower-Speaker/dp/B010OYASRG/

You can test for intermittent contact by attaching your VNA and then flexing the wires, connections, etc. until you find the offending part. 73, Don N2VGU

It is typically well beyond what is needed to measure an antenna's impedance which varies slowly with frequency compared to, say a crystal filter. 73, Don N2VGU

Using this would be my approach, rather than attenuating the signal by 26dB and re-amplifying it by 29dB. 73, Don N2VGU