开云体育

Kit. But if there is a problem with the ADC due to fabrication or bad parts I think Hans will have to know. Then I haven’t the equipment to do a swap of the chip. 73/Mikael

Thanks Larry.

Mikael, Is your radio factory assembled or a kit? JZ [email protected]> wrote:

I have posted a ticket on QRPLabs website and have given Hans some pics and screen dumps. I am awaiting his next response. But as it is Easter ? I do not expect anything until it is over. 73 de

FYI Nominations <http://www.arrl.org/technical-innovation-award> must be received at Headquarters by March 31. Additional support information must be received at ARRL Headquarters by April 15. Don't

Rowan, Thanks for that. Done 73/72 John M0JBA

John, The nomination already exists. Just email Steve Ewald ( sewald@... ) to add your endorsement. 73. Rowan. G0KLH.

I am in the process of nominating Hans. What should I use for his address, phone and email address - his QRZ entry seems to be out of date. 73 John M0JBA

Excellent.. thank you.

Hi Scott, T507 does provide a DC short to the BNC connector.? It is normal. 73 Evan AC9TU

Before I add the BNC connector I am measuring a short between the BNC centre and ground. I suspect this is not correct but I'm not certain?? Is is possible this was caused by the neigbouring

Done!!

Sorry to bring this up, but I've seen threads with no solution. Having just completed what I thought was a very careful build of the QMX, I get no response other than a clicking sound both when I

Hi Don. Just to be sure, you had mentioned that you had been using your "standard 12v supply" with your QMX. Does that power supply provide exactly 12v? The reason I ask is that my "standard" power

In my quest for understanding “What the %#@& ( %@6 ) am I doing!” while Googling about the Internet, I came upon the following resource that most (perhaps all) users of the digital modes (Using

W8DIZ “Diz,” from Kits and Parts SK, R.I.P had a really cool way to do this- Use a 78L05 regulator tied to the amp B+ in (~22V in the QRP Labs case) Tie the output of the regulator to amplifier

Hey all, I suspect this has been asked and answered, but I cannot find it. I have an elecraft k2 with an amp keyer jack that is an open drain output and is pulled to ground during transmit. I would

A new chat has been created: Hello, I've finally finished my QCX (40m), which I purchased in 2019. Surprise, surprise it does not work. I'm hoping it is not due to me having to substitute NTE490

That might be a typo in my notes. I used the same torroids in the QMX kit. For L401 I used the one from the high band kit. 73, Bill, N6MTB

I must agree with you about the 465.? I had one on a cart that I used nearly daily for 20 years.? Even when I had a Tek 7904 with all sorts of plugins, it was just too big for my shack workbench, so