开云体育

Your usb connection on the board itself (the soldered connector) would be the next place to look. I have dozens of USB cables and a few are fussy about seating- worn out I guess. Larry KB3CUF

Guess not. Brad, AB4BA

Glenn, You need two things. One- set the QCX for straight key mode and tip for straight key. See the operating manual. Two- you need to use a STEREO plug, but you only connect the key to TIP and

How long was your coax ? In a EFHW, the coax becomes the counterpoise so depending on its length (especially if it is short) CMC can happen. You can try lengthening the coax or adding a counterpoise

Hi Mike, no, not at all!! SWR was fine! thanks! joan

Fantastic work, Hans! The only glitch I can find is that the battery voltage stops updating after a while. It stays like that even after a power cycle. This is triggered by decreasing the Update

Kevin, I just tested 016 with FT8CN. It used to stop transmitting after the first transmission (I heard of similar issues with fldigi). But now it transmits on every second 15 second interval like it

SWR protection kicking in? -mike/w1mt

Hi there, today I did a double SOTA activation with the QMX on 10m, mainly. I bagged a total of 31 QSOs, 16 of which with USA, both East and West coast. With 10 Volts, QMX was TX with 2.5 Watts. I

I can no longer reproduce the speed save issue. Go figure. 73, Mike KK7ER

In addition to "Keyer Mode" there is also a "Straight Mode" where available settings are “tip”, “ring” and “both”. Experiment to see which works for your key/cable. -mike/w1mt

...yep, I suspect a cable problem.

Yeah, fat fingers. I tried that menu item but the key didn't work, could be the cable. Thanks.

I think you mean "QCX Mini" and yes, there is an option to use a Straight key - it is in the CW menu.

I have a OCZ-mini 20 meters and tried to use a straight key with it. Didn't work. Can a straight key be used on the mini or just paddles? I'm pretty new to CW, so I probably haven't a clue what I'm

Dave, I'm guessing, did you get a message direct from groups.io? If so read it carefully, replying here is not an option. 73 Alan G4ZFQ

I found that I had to set CW-R to 'on' and change the sideband to LSB.? Now CW-R is working for me. Don

Firmware 1_00_015 was giving me keyer issues with extra dits/dit timing.? I installed 1_00_016 and I am not seeing any issues.? They keying is like all my other keyers and feels right.? No longer

Please keep me on the list Thanks -- Best 73 ~ Dave ~ G8LIY

Hi Hans. First huge congratulations on the great state of the firmware for CW operation. I did load _016 this morning and gave it a bit of a workout on CW for 15 minutes or so. I only have single