开云体育

Thank you Scott, I think I’ll give that a try as well. Cheers Dave

Fantastic. The spirit of ham radio ! -- - 73 de Andy -

Nice setup. This gives me ideas for the station I want to carry on hiking trips in the mountains with the YL. 73! Kevin N8MXL

Hi David. I had similar issue. Had continuity between the A points if I touched the tip of the wire, but only continuity between one set of A pads if I touched the pads. What that told me is that one,

QMX performed very well during today's SOTA activation and QSO'd with 31 stations including seven W stations from 14MHz to 28MHz. I found some problems with QMX during the activation and I would like

Hans Summers kirjoitti 3.2.2024 klo 15.10: One more thing: The S meter doesn't work. In the fall I found a discussion about that, but at least it doesn't work for me. Or does it require

Brilliant! I love it. Can you tell me about your USB-C trigger board? Did you make or buy? Thx Matt

I've just done a handful of qsos on my QMX, one of something 700+ miles and need to say I love it! There are a handful of things (software) that might be tweaked: - agc (yeah, I know, I know - will be

Thanks for all the reports and feedback, thank you very very much... all great stuff. I am working hard on the firmware today, fixing a number of bugs. I have the WSPR beacon function working

Sandy I only had 1-MDC QSO, which was not yours.? To bad.? 40-Meters was kind of long for me that weekend.

So I've been given v15 beta some hammer just keying out news stories for 30 mins or so in iambic A into a dummy load (so it is outputting RF) and it is MUCH better in terms of incorrect dits and

Peter Li, One more thing. Take a look at the peak non-repetitive reverse current spec for your Zener diode, in light of the discussion above. The 1N4758A spec is only 80 mA. I think that diode spec

Hi Adrian, tnx for checking, which led me to do a Factory Reset once again. So now storing of cw offset and sidetone freq works as expected :). Still the pin-association for a straight key works in

Peter, Your 56V Zeners may not be protecting your PA transistors from the L14 spike as well as you hope. We tend to think of Zeners as being a hard clamp at their spec voltage, often neglecting the

Many thanks Ernie QCX is a great and very special radio. Despite all the advantages of the QMX I am absolutely intending to keep the QCX+ and QCX-mini going for as many more years as possible. They

Sorry, I meant to reply to Roy's post about the less frequent but still noticeable cw glitches. 73! Simon

Can confirm! I'm experiencing the same on a high bands QMX rev. 2 at 18-20 wpm.

I think I found a small bug, but I can't tell if it's particular to this firmware or it was in 0_14 as well. While changing LSB/USB via "PC and CAT->CAT command test" menu with the Q11/Q10 commands

Hi Matt, perfect setup for the next QCX WARC Party or Challenge.? We would love to work you there. Martin DK3UW

Hello Cedric, I've changed both cw offset and sidetone freq., and it saves both settings. I also tested with a straight key, and it behaves just like old firmware (that means it didn't need any