开云体育

The keying and the gps share a port, so you have to put cw in practice mode so it does not key the transmitter. Paul To: [email protected] Sent: Thursday, November 23, 2017 2:26 PM Subject:

Two spaces in front or a space in front and a space in back, neither work...

I saw that in the instructions too. I interpolated my 2x1 against Hans 1x3 call. Hans had to add a leading space to make his callsign hold six places. I probably needed to add two leading spaces not a

I had to read the instructions to find that the callsign must have a leading space. don't know about a trailing one though..... g4ksy --- This email has been checked for viruses by

I wasn't trying to practice. The problem manifested when I turned Beacon mode on and it immediately started to transmit but not in a normal manner. I turned Beacon mode off and the CW transmitter

That's the same one I have. A couple of upgrades I made and I highly reccomed if you haven't made them are the all metal micro swiss hot end and a piece of borosilicate glass for the print bed. I also

Yes,? it will switch to transmit.? You have to turn on the practice under the keyer menu, then go to the calibrate menu.? It will then work fine Paul To: [email protected] Sent: Thursday,

Gremlins might live in rev C and rev D. Last night I plugged the GPS in and calibrated. It worked great. After updating to rev D I plugged it in and it started transmitting. I made a video of it. The

Yup. Downloaded Rev D from the site then sent to the QRX again and all is well

Rev C works. I'm going to download D agains see if it was corrupt

Well crap.... I converted my working QCX to a display that says 5W CW Tcvr 1.00d QRP Labs,? 2017 But that's all it does. Buttons don't work. Encoder doesn't work. Key... nothing works

It's the first time that I've actually been successful programming an Atmega chip. I'm talking YEARS of trying to program an Atmega chip. PIC's,,, no problem. I've got Atmel's software. I've got their

Will do!? I have a Maker Select V2 waiting.? I'm sure I'll have a bit of a learning curve and time into dialing in the proper print settings.? Thank you again! Kent W9WB

Good afternoon Alan, Thank you challenging some of my comments. As to my comment regarding 11025 sampling frequency, I checked the WSPR and WSJT-X documents and found 48,000 mentioned as the

Which chip did you use for the QCX. I am trying to detect the 328 or 328P in AVRDudess and it's not seeing either. I'm using and AVR MKII and it seems to be happy (two green lights and recognized)

Here is most of the grabbers in the world collected in one page.??http://swharden.com/qrss/plus/

Al, I see nobody has answered your other question on the encoder yet so I will.? Mine fits a piece of .1" spaced vector board just fine so yours should as well.? That spacing seems to be pretty much

David, What symbol rate are you recommending. Is it 6 like in the U3S documentation and do you want QRSS or FSK/CW? 73, BrianB N6CVO

To change the tune rate, simply press the encoder knob. Check out the 'cheat sheet' at the end of the manual for all operations. ? Steve, N4IAG

Love the short version, Dave.? Again, thank you!? Hoping to get my printer dialed in shortly after Christmas, but this will likely be one of my first prints!