开云体育

Gang, The QRPBuilder magnetically attached Iambic and Single lever Paddles are now back in stock. Also, this will be our fifth year at the Dayton FDIM vendor night on Thursday May 15, with all our

Nice work btw.. If the qmx is in Practice mode, no SWR measurement is possible, but it is showing everytime an SWR? 1.6-1.8, and SSB will still work.I was working on a linked dipol. Maybe the should

Except that one has to learn writing commands from scratch. I hope you are not going to suggest using one of the free GUIs that sit on top of Linux. Been there, done that and had to format the whole

Very glad my suggestions helped and you got it working.? Have fun with it!

Thanks Donald - quite right. I’m probably going to do what Jim is doing and just keep it a QMX / QDX only amp. It’s just a fun little project to learn about and really appreciate the author

If you’re running anything pre-Windows 10 which is connected to the internet you’re really asking for trouble. However, rather than splashing out on a new whizzy machine, many older machines will

Might this be why I suspect my PA might have failed just now running calibration cycle? I know I didn't need to but I wanted to see it run the

The operating system that Hans uses with his QMX+, or one similar, should run on your existing hardware at no cost.

Interestingly it looks like the cathode tab of D516 is not connected to the solder pad, looking like it might have been touching but now not; I'm wondering if this might have caused it.

Afternoon all, Well, it was all going too well. I had been using the 003 SSB firmware with good success and decided to flash the 004 update...this went well but I decided to run a calibration cycle

Hello Brian, may I send you my bank account number to get money to by all the new stuff to use for field operation? 73 Ludwig

I use FT8CN in POTA for activations (Android). Calling CQ works well. Searching, e.g., for P2P QSOs, is more difficult with the limited screen. The configuration settings are sufficiently commented

I would not spend any time making changes to support end of life or soon to be end of life operating systems.

Hi Stan … I had set my polling to 10sec as Hans had suggested. Thanks for your input. Dick, K5AND Sent: Thursday, April 24, 2025 1:34 AM To: [email protected] Subject: Re: [QRPLabs] qmx

Good morning, Hans … I am using Windows 11, 64 bit. Only WSJT is connected and other two ports unused. The system plays nicely for a short time and then drops the ports. After turning radio

On 4/23/25 I had a CW practice / rag chew session on 20 meters. I worked two stations: Conditions were OK. SSN = 142, SFI = 163, A = 12, K = 1. Early on I heard a couple of weak stations calling

I'll have a look at adding additional CAT commands to FLRIG in my next play-time :-) Great to have the multiple terminals - FLRIG shown doing its stuff with the terminal monitoring CAT commands. As

Thanks for the reply. I have enough cores to stop and stray RF I will try that. I have reread the manual and see that the power I referred to is ‘tx status’ and I will make the changes you

Excellent work Hans, I applied my hack on udev to get the new ports consistent, and now my machine shows: /dev/QMX00 -> ttyACM0 /dev/QMX02 -> ttyACM1 /dev/QMX08 -> ttyACM2 So I can now use a

Hi Dick and Richard, You reported COM ports got dropped in the new firmware - I have not seen any problems. But I am using Linux. It would be very helpful if you can provide more details. What is