开云体育

Screenshoot 80m phase error after factory rest

I have a similar pattern in the ‘80m phase error vs DAC’ as Mario Vano AE0GL. I have done a factory reset, no change. Any ideas for troubleshooting? Many thanks to Hans for the SSB software. I

This is correct,? and is the issue. No need to update or change WSJT-X.? ?If you have Hamlib v2.6.1, simply choose QDX or TS-480 as the radio type.? The QMX type is broken in this version.? You

Chris, I've been working through this series of YouTube videos...I think Allison may have recommended them previously. I've yet to download LTSpice, but the videos cover that,

Sorry, the best place to get it is here https://wsjt.sourceforge.io/support.html It tells you where to put the file. 73 Alan G4ZFQ

Thank you Ronan. I could not remember what it was called.? Tinsel wire. YUK! Even if you do manage to get that stuff soldered,? it will likely not hold up to any strain

Chris, "Authorised" in so far as it is open source. The variations are not promoted on the main WSJT-X page. Like the RC versions "improved" versions are best used by more experienced users. The

10 meters but they give good output on 6. Tony AD0Vc ________________________________ Sent: Monday, March 24, 2025 4:56 AM To: [email protected] <[email protected]> Subject: Re: [QRPLabs] SSB

This is a 9 volt build. It is supplied through an LM338 regulator adjusted for 9 volts. The regulator input is from a 12 volt linear bench supply. The BS170s came from Mouser. They were mounted

In the QMX+ I just mount them face up with the washer as usual. In my QDXs I have experimented extensively with heat sinks and I found that heat was never an issue. I do not run WSPR, mainly

Are you using VOX? I had the same issue until I upgraded to latest firmware and back to cat PTT control. Chris, w0anm

I loaded 1.01.003 last night and ran the calibration routine. I thought everything went ok. I cycled power and started tuning around the bands. The first band I tried was 40 meters. I heard a group

KJ7RBS (I think) did yeoman's work in getting the QDX to work with VARA.? He suggested setting: Rise Threshold to 65 (default 80) Fall Threshold to 45 (default 60) Min. Samples to 120 (default

Darrell, Did it only happen this one session or does it happen every time you use your QMX in SSB? 73, BrianB N6CVO

Congratulations! -- 73, de BD8BTE op: Lun Yang

The bandwidth of an AM receiver might be 10khz, the QMX strips out all but 3.2khz of that AM signal. While it is harder to tune in with the QMX, if there are interfering signals within the 10khz AM

Nate, When Allison says a max of 16 volts, she means the power supply into the rig. Transmitting on 80m with the QMX from a 12v supply into a 50 ohm dummy load can cause peak voltages of more than 60

Paul, Okay thanks! Dave W6MQI

I'd appreciate some pointers to guidance on RF circuit design, especially power amplifiers.? Some sort of text book maybe. Chris, G5CTH

Dave, I have an old set of Radio Shack communications headphones that are mono. I use a mono to stereo adapter plug on it and it works fine. It's similar to this