开云体育

OK, I have upgrade to 1.05 and have no problem LA5VNA Steinar loc:jo59jq www.opera.no Den 25.09.2012 23:26, skrev Paul:

Hi, Sorry, forgot to mention, the welcome text shows V1.05. Paul PE1OKU.

Hi I had the same experience with an earlier version of the software 1.01, but upgrading to 1.04 everything works fine. la5vna Steinar Den 25.09.2012 23:14, skrev Paul: But, in many menusteps the

Hi, Today I have build the Ultimate QRSS kit (30m version). Building it was easy, xtal is running and the display shows welcome message at start-up. However, set-up is not possible. Both buttons are

Hi Philip, thanks for your reply you have given me an idea I have already checked the solder side of the PBC (will check again) but I have not checked the component side of the PBC which could also

Ive seen this happen...(cycling) On mine I once by mistake left a wisper of wire shorting the output of the PA. On switch on it would cycle between mode and welcome screen... So Colin, double check

Hi Steve, thanks for your reply I know you and Hans have been very busy with the divide by 8 problem, I will have a look into the time thing this evening, I think the power supply is OK the batteries

Hi Colin, What you have described partly might be explained by a lack of capacity from your batteries to power the beacon on transmit. So there might be something wrong with the power supply or the

Good Morning everyone, this is the third time I have posted this message without receiving any replies, 3rd time lucky maybe ;o) I have finished building the UQRSS kit for 160m and was entering the

All As Steve mentioned, v1.06 has a "Reset to Factory" feature. If you press the right button during the first few seconds after switch on, while the version number splash screen is displayed, then

Hi Steve, good job on sorting out the problem ,will you also be able to send my order 879 from 14/9? 73 Colin

Hello Steve, many thanks for your work. Meanwhile I've got a GPS-receiver with a 1PPS-signal: Seems to be same slow. But now I'm looking forward for your letter. 73s Stefan, DL4GCS

Guys, First of all may I apologise to you all for the mistake I made programming the chips. As far as I can tell the following people received them :- Tony, G0BZB, Stefan DL4GCS, Gordon

Paul KE7HR Experiments here and work with G0UPL on using various diodes as varactors, including real varactors, seems to indicate that using multiple varactor diodes or LEDs-as-varactors does not

Lower frequency crystals are harder to "pull" or "push" off frequency as a VXO than are higher frequency crystals. I did experiments a few years ago when building a five crystal VXO for a radio

There are several ways to 'pull' a crystal off it's natural frequency. We see a simple series capacitor quite frequently. Adding large amounts of inductance in series with the crystal also works.

Hi Philip, I have no experience with the UQRSS kit but a few tricks can help in pulling a crystal a little bit more. The more simple is to to put two crystals in parallel. Take care that will change

Should have mentioned, I had a one off crystal made by QuartSlab UK for 20 meters and it cost more than the UQRSS kit... Worth it though :)

Running a single BS170 PA about 200mW on 20 meters into a 132' Windom at 20' The little kit did well I reckon... Philip G4JVF 2012-09-22 05:48 G4JVF 14.097191 -23 -4 IO93if 0.2 ZL4VV

Hi Svere, Just by chance on my second kit which has sockets for plugging in components, the crystal leads were left a bit long so the crystal isn't sitting with its base on the circuit board. Also,