开云体育

Does it behave the same way in practice mode?

Hans, That's great news! If there's nothing that I need to troubleshoot, I'm okay with that. I'll keep playing with it. I did attach a short video of what I experience. I must tell you that the

Nice. ? I use similar techniques on things that are dead already, ICs with a central (often ground) pads underneath and/or where the replacement is on hand. A clamp holder gives me one hand back as

Problems arose after updating the firmware. The device freezes when changing the frequency and entering the menu. I went back to the earlier firmware, it works best with version 014 and 015, it

Hello Jacob It could be an op problem, not a radio problem. Not trying to accuse you unfairly - just saying, it does happen. Some radios' keyers have different characteristics to others, and you can

Do you have a lot of local noise? AGC is only active in cw mode... 72 de va3rr

Thanks all, I tried cleaning the contacts but I notice the issue even if I short the dah side wire to ground and bypass the contact. And I don’t notice the issue on another radio. I’ll try the

Hey Steve, Thanks for your note. I tried to clean the contacts to no avail. I also tested just shorting the dah side so I could bypass the contact altogether. Same result. I notice it in practice

That's why I was expecting / hoping for, but it doesn't seem to be the case for my unit. It's really unclear to me why all signals seem to sound so weak with the CW filters active. If I'm

Hello Daniel,Just curious - are you able to receive any signals?I realize that doesn't necessarily have anything to do with transmitting, per se, but if receiving is OK that may narrow down the

Very curious.? This would be a good question for Hans.? What in the circuit could cause the transmitter to fail to key unless the sidetone is put in relative mode?? I don't see any connection

Mine seems to behave opposite - the amplitude is significantly higher via filters in CW mode than in Digi mode, or when no filter is set in CW.

Interesting. So the bandpass filter scan looks good?? I was under the impression that the BPF scan uses the same signal source that does the LPF scan (I could be wrong).? If so, the scan signal had

You know SWR protection is activated because 1) an 'S' appears in the display right after the frequency, and 2) the transmit power is turned off.? You have to manually enable transmit again by

Protection is set at default 3:1. low pass filter isn't showing a curve, and SWR sweep is displaying >10:1. But the other diagnostics are all reading as okay. SWR protection warning is stated in the

More ... It seems if I enable Rx Outside Band, it works. But from then on both VFO's get messed with. What was in VFO A or B may change upon Power Down. After power up, I may see a different

How do you know the SWR protection is activated? What indication is showing on the radio or in terminal mode that says so. I’m just asking because I am curious. Myron WV?H

I have 3 QCX-mini transceivers that I've built for various bands, and today the center pin on the BNC antenna jack broke when I was disconnecting my antenna feedline from my 30 meter QCX-mini.? The

Could be one of many things - we need more info.? One likely culprit is problems with the output transformer T507: primary/secondary windings shorting, soldering fault, enamel not completely removed

The protection level is adjustable isnt it? What do you have it set at?? -- Compton VK2HRX Sydney, Australia