开云体育

I have the same problem with the constant carrier, apparently Steve and Hans are aware of the problem and are trying to sort it out and will be sending out new chips when the problem is solved. Vy

Hi Kevin, just to let you know I have the same problem and also mine sends a constant carrier so the only mode I can use at the moment are the Hell and test modes. Vy 73 de Colin DD5CF / G1ZOS

Yes I had the same problem Nigel. Found the CW output on Pin 16 of the PIC instead of Pin 14. I carefully cut the track going to pin 14 and used some very fine enameled wire to join the track with

Just completed my QRSS kit and discovered there is no output on the CW modes. The keying should appear on pin 14 of the PIC but nothing is there. I discovered the CW output on pin 16 (an unused pin in

Hi Folks, I have my QRSS Ultimate built and am trying to program it. I am attempting to WSPR as my setup. However, when it goes to run it comes up with Message Error. I only have my callsign NZ1I in

Thanks Dick Will go have a look :) Philip G4 JVF

I now have WSPR running on the Raspberry Pi with the latest raspbian wheezy on my SD card. WSPR works but I have problems with using a CAT cable as the RPi USB doesn't seem to like the load of the

More info..... Pin 14 of MCU is low all the time. de Nigel M0NDE

Hi I have just completed the kit. My pcb had green varnish over the lands where the lpf connected I had the scratch the varnish off. I have programmed the kit but only seem to get a carrier out

Hi Hans, I have just brought one, not too bad for ?24.00. I have noticed that I will have to put a 3.3v regulator (L78L33) and a couple of caps in line to use the 5v GPS supply on your board. 73

Hi Andy I too would love to get my RaspberryPi setup as a grabber (low energy costs). Since there is no audio in, then it would need a USB sound dongle I presume... No idea about software but fingers

Hi All I have only just joined the group and have built 2 QRSS bacons one for 10.140mhz and 7mhz. Have done nothing but test them so far... My intention is to set-up a grabber on 7Mhz I have several

Hi Steve Many thanks for the info and advice.. will wait till I hear later from you on results. Am anxiously awaiting delivery of the kit. I have had stuff from Maplins in 7 days, stuff my son sends

Thanks Hans... I liked that one because it's easy to add an external antenna... Might take a chance and order one.. Philip G4JVF

Philip, http://www.dpieshop.com/trimble-silvana-acm-with-condor-gps-sma-antenna-connecto&#92; r-p-717.html<http://www.dpieshop.com/trimble-silvana-acm-with-condor-gps-sma-antenna-connector-p-717.html

All, Just to add to what Steve already said about the GPS: 1) When the GPS is enabled (menu configuration), you MUST have the 1pps GPS signal present, because it is used for the timekeeping. When

Tony & all You can also set the time in the last configuration menu item. When you press the left button after setting the minutes digit, the set time (hours and minutes) takes effect and the seconds

Been looking around what's available in GPS modules... I know little about GPS but just hoovering up information.. :) Came across this site which has a good selection and some modules seem a decent

Hi Alan, Thanks for the message and raising the subject of GPSs. Hans and I are doing quite a bit of work with GPS at the moment and hope to recommend some that we know will work with the kit. We

Hi folks Have ordered the kit last week and after reading the online instruction I noted the GPS interface. Question – what type GPS receiver is used. I have a GPS receiver with external antenna