开云体育

Is there a resolution to the lack of xmit audio ? (Which I am experiencing ATM with v.017 on the QMX, and v0.92 of ft8cn. TIA for any sort of answer ! es vy 73 de "Baab" w9ya

Burt, I'll check out you screen shots later. Thanks for posting them. [email protected]> wrote:

Burt, That current draw in TX is quite low. Check continuity through L502. In TX the four PA transistors will have an RF square wave signal at the gates . The magnitude of that signal is 5 volts and

I have a high band Rev 3 kit ready to build but there's no Rev 3 instructions. Do I just use the Rev 2 instructions? I really think I have missed something obvious here regarding build instructions

Hi to the group ! I have a few QRPLabs radios not yet assembled and I'm now considering my power supply options.? I have some hearing loss and tinnitus so a quiet radio/power supply will be a great

Hi Mike. Compared to my High Band QMX, yours seems to be at least 30 dB in the deaf direction. In your case I don't think it has anything to do with the lowpass filters because your output power

Hey John, thanks for the reply: All bands no power out. Verified that no input exists to the antenna tuner. 12 Volts for power. 97 milliamps on receive. 60 meters - 141 Milliamps xmit 40 meters -

Peter, How were you powering the ProgRock2?? What sort of voltage source, voltage level, and connection method? 73 - Steve, KW4H

The second failure was with Vcc at 9V. Power at about 1.2W.? Last sentence of the first paragraph. -- Chuck, W5USJ EM22cv, Rains Co., Texas

Burt, Some questions. Your answers may help your helper. Are all bands exhibiting no power out? Have you verified 'no power' using an external instrument? What voltage level powers your QMX? How

Thanks for your agc settings. I will give them a try. 73’s Mike Krieger wrote:

I have discovered by accident that the HRD profile for "Kenwood TS-570" seems to work better with the QMX than most of the other Kenwood profiles. The audio does not disappear, CW reports to the

I have no power out, yet the oscillator is working as I hear it on my DX10 when the DX10 is not connected to an ant.? I ran hardware diagnostics on the rf filters.? They were pretty much a strange

Hi Folks.? I just want to pass along my AGC settings.? They are somewhat based on what others have posted plus some of my own tweaks. I have not spent much time on the noise filter parameter as the

I have seen quite a few a few posts on sensitivity on the High Band QMX, but I am not too sure what to do if it isn't up to snuff...My Low Band QMX sensitivity is about -107 to -109 dbm at the antenna

Steve, My Progrock2 initially ran very hot. I was able to connect via PC to the microUSB port and set the frequency, but at high frequencies (above 135MHz) the output becomes unstable/noisy and gives

The QMX firmware version1_00_015 and up implement the CAT command TM for get/set of real time clock. I created a small powershell script for windows to set the time (see

Good morning (In the States) Hans! I used a little 'Burt' force, and by alternating screws from each side and opposing corners i got it together with a good fit.? Thanks, I was afraid to put too

I have had it happen before with other extruded aluminum boxes where the fit between the two halves is not perfect. I use a pair of smooth-jawed pliers to give a very (slight) bend in or outwards on

Hello Burt Series they're slightly off and require a lot of force but I can't recall having seen an enclosure which wouldn't snap together given enough brute force. But if you need me to send you a