开云体育

Hi Hans. Hopefully you'll pull the release from the QMX page until this gets figured out. My QMX does show up with it's USB Serial Device (COM4 in my case). But PUTTY won't connect to it. PuTTY

OK... I nearly found it... WAIT... 73 Hans G0UPL http://qrp-labs.com https://www.buymeacoffee.com/g0upl [email protected]> wrote:

Hans, I do have a few of these to overnight to you if your looking for quality soldering irons that last and need quickly ? Just trying to help......

Hmmmm Interesting... well best people WAIT a little bit... while I think... 73 Hans G0UPL http://qrp-labs.com https://www.buymeacoffee.com/g0upl

Yes - this is my issue.? It did boot to what looked like to be a working state once however all controls were frozen.? On reboot it was back to this initializing state...

Same here… Sent: Friday, February 16, 2024 9:39 AM To: [email protected] Subject: Re: [QRPLabs] #qmx #firmware 1_00_017 AGC, S-meter, LPF sweep Hmm - apologies for the numerous

Hmmmm, I just followed the usual procedure to update the firmware to 17 and having placed the new file in the QMX pseudo-directory, the lights didn't come on again. I waited a while and eventually

Mine just got stuck there as well. Rev 2. I cycled the power and it got past it but was locked up. Cycled again and it gets stuck at that screen. Putty won't connect in either case. Brad W8BMO

I just upgraded the firmware to 017, and the display after it re-started just showed "A14.030.00P" followed by an battery icon indicating the battery was empty. It was in practice mode before the

Hmm - apologies for the numerous posts. Rebooted and it is stuck on Si5351A again.,,

Do ignore me - a forced firmware boot and re-install and peace seems to have been restored.? Will test and report back any other findings :) Top work as always Hans

A few months ago I successfully built the low band QMX, and it was fully working. This week I had a short interruption of the power supply, resulting in a blown D108. I replaced it, and also updated

Hmm - just tried to update my rev1 lo band and it is stuck on Enable Si5351A. Anyone else stuck at this point?

Oscilloscopes all have very similar controls, your text should be applicable to them all. I have 2 Hantek 'scopes, one the box type and the other essentially identical except that it is headless; all

Bravo, Hans. ?It looks fantastic.

I believe that in the newest firmware as of now (016) that the QMX will mute the sidetone when the transceiver enters protection mode. But that should not make it lock up. I experienced a total

Thanks Hans, Installed V17 and the digi enablement is working perfectly.? Very happy. 73 de ZR6TM Timo

Hi all I have released firmware 1_00_017 at http://qrp-labs.com/qmx The most important features are the AGC and S-meter. S-meter: it appears in the 3 characters to the right of the mode

Thanks mate, very nice of you to give this attention. 73 de ZR6TM Timo

Is there a reason you're not merely using Practice Mode? You could check your dummy load using an SWR meter or a NanoVNA to make sure it truly is 50 Ohms. -- 72/73 de Steve,