开云体育

Its good to give a new use to an item you probably don't need anymore otherwise. :-)

Hi Tony I think there's quite likely a difference in experiences depending which side of the Atlantic you're on. FedEx seem a lot better in US than they are in EU or Asia. And DHL Express may well be

Hi Peter I can see the glitch on Audacity; it's there but I find it almost inaudible particularly when on the bands not on a dummy load. I also went back to earlier firmware versions back to 1_00_009

Having done some further testing there are definitely still some keyer glitches with some long dits in particular and the more occasional short dah.? It is way way better than before however it is

Same here although the personal perception is they are very distracting even in low to medium volume.

After you suggestion, I did perform the factory reset. Initially the thump was a bit quieter but this was only due to a relatively low volume set after factory reset. When I raised the volume the

On the Tx to Rx clicks/thumps, they are relative to volume level setting - louder with higher setting. They aren't very annoying at low to medium volume settings. -- 73, Dan? NM3A There are moments

Hi Ronan What method are you using to try to switch to LSB mode? I'll try to reproduce it here! 73 Hans G0UPL http://qrp-labs.com https://www.buymeacoffee.com/g0upl wrote:

When trying to listen to SSB signals in digi mode, it used to be possible to switch to LSB in order to hear stations properly in the lower bands. This no longer seems to work. Not the end of the

Hello Danny Since version 1_00_012 the sidetone volume defaults to 50 on a factory reset. But if you mean the firmware update itself doing it: having the firmware update default a parameter during the

Hi Ludwig Thanks, noted, I have added that to my list. 73 Hans G0UPL http://qrp-labs.com https://www.buymeacoffee.com/g0upl >

Hi Kevin Could you explain please? QMX doesn't do SSB yet so I am sure that "LSB not working" is not what you really mean? That issue is the same as the FT8CN issue, I have not addressed it yet. As I

Hi Pete Thanks for the feedback but none of these are new issues, they are all there in 013 also. For now, I am going to try to do bug fixes and enhancements ongoing, and do a release once a week or

Hans, I have updated to V14 and these are the issues I spotted within half and hour: 1. There is an awful thump when the switching from TX to RX. I have not noticed it before to be honest. It is very

LSB not working FLDigi still cuts out 73

Hi Hans, For me the clicks are much louder. They are almost as loud as the sidetone itself. 73, Mike KK7ER

Hi hi! -- Paul -- AI7JR

Small error in v14? sending on 40 m in CW (rf and side tone ok) going to Menu - Hardware tests - Tune SWR - left button to start - left button to stop 3 times the right button to leave the Menu and

Great work Hans. Really enjoying the QMX anyway but with the fix to the CW keyer it's going to be much nicer to work with. I need to test it more fully however I *think* there are still minor glitches

I am! Thanks. I would never have done that w/o being instructed.