开云体育

How does the QMX behave with a 50 ohm dummy load? If the QMX reads a low VSWR with a dummy load, the QMX is working properly. In your previous post showing the Putty screen, VSWR was shown as 1.94 to

Hi I'm reaching out to the experts for advice, guidance & help please. The Hermes Lite 2, "HL2", is a DDC/DUC SDR transceiver - http://www.hermeslite.com/ - which can output upto 5W PEP RF. The RM

Hi Francesco, The green ”COLOUD" speaker that Steve links to is decent and very lightweight. It doesn't have great battery life though, at least my one doesn't. The Anker Souncore mini is also

No problems with a straight key on any of my QCX's. The only time I had a issue was when using a particular amplified Bluetooth speaker. Even though I was plugged into the line input, there was a

I haven't heard of this issue before, but I have experience different audio anomalies with different headphones.? Sometimes it's just the impedance of the headphones, or the connector. I have trouble

Thank you for your suggestion. So I followed these 2 videos * How to measure coax loss using a NanoVNA ( https://www.youtube.com/watch?v=OSw9Epu4nu0 ) * NANOVNA Return Loss vs VSWR (

Typical pot setting as the IRF transistors start to conduct (yours may vary, increase very slowly )

I also take from this single poster, that no one else has had this experience? If so I can get around it by using a paddle, I can also try using a bug.

I've now sorted the power problem on 6m. It appears that the inductors L519 & L520 are super sensitive to turns spacing, tweaking those improved the O/P power, but the main improvement came when I

I'll make a video later when I get time.

Is it possible that is the sidetone sounding a little soft?? Maybe you could record a little of the sound and post it so we could get a better idea. -- 73, Dan - W2DLC

Thanks for your explanation. I'll buy you another coffee - hope you can get an iced coffee during the summer. Chris

I am also a fan of the 1050 case. Additionally, I have this 3D printed cover ( QMX cover and desk stand for hamradio POTA SOTA by F4EGX - ( https://www.thingiverse.com/thing:6599009 ) Thingiverse)?

If this were me I would first completely calibrate the VNA for a bandwidth of 13.8 MHz to 14.5Mhz to zoom in on the 20m band, so that you can accurately read the Return Loss across this narrow

I like this Anker speaker too. Battery lasts very well, sounds good with QMX. Also sounds good with music, with good Bluetooth range.

Hi Chris Software. I don't think they're flattened. It's a limitation of my ASCII art, I think that's all. Everything on the terminal has to take place within the constraints that there are 25 rows

My QMX was delivered the other day but I have not been having a very good time with it so far. I am really hoping it is because I am just dumb! It came shipped with the 1_00_019 firmware. I put 11.7v

I just wonder why the peaks of the sine waves are flattened.? Is this a hardware or software saturation?

Hans, Thanks for the CAT fixes! Works great now with DXLabs Commander!! 73, Randy, KS4L

Problem resolved! Happy again. There was a short on the 3.3V Buck converter, between D102 and Q107. D102 was soldered not precise on track and made contact with Q107. Had to replace the buck