开云体育

They might have had a shot if everyone had limited themselves to one They did have a shot, same as everyone else who tried to order. Sooner or later the kits run out, and no matter how many hams got

Nice set up! I’m relegated to the kitchen table! Takes forever to drag out test equip & tools…. Then it’s lunchtime ? jim

I didn't see it as a knock against Hans. He has gone over and above. My gripe is with those who purchased more than one for whatever reason. When a supply is so limited it just comes across as a bit

Wow! I was hoping the fairness police would never invade this little corner of Ham Radio. I guess we're not safe anywhere in these times. Seriously guys, what has Hans done that's unfair? Other than

I've been moving my shack from an upstairs bedroom to a downstairs one and building new benches. I just finished putting together a Mercury IIIs amp and have several couplers to build. Rewired the new

My last word to the Troll Can you share your certifications and reason for your "expert advice". Also I have not seen your vast cache of non drivel videos yet. Please remove yourself from this list.

New PiZero2w as fast or faster than my?older 3b and for comparison I have 3b, 4, and new zero 2w. I would suggest you run Buster until Bulleye is fully vetted. I’ve run both OS?and it took some

Where is the troll when one needs him(it?) it ought to be: "be worn down". :-/

Johan- Thank you for the reply, very helpful! I can't duplicate it, but the image problem seemed *possibly* intermittent once today. Right now the QDX is happily running solar-powered remote to the

Well, as Hans pointed out, it doesn’t make a lot of sense to have multiple QDXs since it’s a multi-band rig. I’m hoping those who ordered multiples were simply ordering for others or perhaps

Hi Evan- Thanks for the reply.... right after building it, my scan looked great. Today, not so. I also noticed that the image rejection looked like it went to more normal after I unplugged the USB and

Although not the least expansive solution, the Pi400 minimizes the required pieces.

Agreed though it would mean more work on what sounds like an already overworked small company. I don't understand buying multiples when so many want a unit and there are so few available. Reminds me

I've got 100 of TA7642 to test.? This is a replacement for the ZN-414 three-pin AM receiver chip from the 1970s, and Ive always wanted to play with them.? I got them for next to nothing from ebay

Hi Jake, Wish you luck in getting the QDX. I have run WSJT-X on my Raspberry Pi 4, and it is slower than my I5 laptop.? If possible I would suggest the Raspberry Pi 4. I have not tried the Pi Zero 2,

RPi 4's, and the new 2's are unfortunately hard to obtain. If you can get one then FLDIGI, WSJTX and other well known stuff should work well with the horsepower that they provide. But since they may

I tried running wsjt-x and JS8Call?on a Pi Zero 2 W and they seem to be working fine, much better than on an old Pi Zero. I need to do more testing, to properly connect it to a smartphone (vnc kinda

Hi Hans, I had a letter from my gas supply company (for all my cooking and central heating) to say my average annual bill will be rising from ?996 pa to ?1995, due to a 250% increase in gas prices

I (hopefully) have a QDX on the way (#52676), and am looking at getting the necessary RPi set up for a portable digital station...? I have not run FLDigi much at all, let alone on a Pi, so...? What

Hello Andy, I am not aware of an adjustment for image rejection, as that is in the software unlike in the QCX line of transceivers where it is analog. What is the Audio Sweep showing as far as image