开云体育

Ok, it wasn't me. I was looking and looking, haha. Thank you for the update.

Made a mistake.? The design is in the File Section at the QRP Tech reflector not QRP Labs.? (QRP Tech is a Yahoo reflector) Lee, w0vt

Chuck ordered test boards from two manufacturers.? He wants to see how well the pads hold up to heat from each manufacturer. Once the boards are proven, the boards can then be ordered using the

Wow! This is is great news! I almost pulled the trigger for a Wilderness version about ten times but waited and ultimately missed out. I'll have to keep my eyes peeled for posts from Chuck. Thanks for

No, Chuck and Company are working on one.? Right now he is testing how well the PC pads of the board are holding up to the heat of a blow torch. Lee, w0vt

So, this NorCal 40A board you speak of... Did you make it yourself?

No word from Chuck Adams in a week!? He must be behind closed doors in his laboratory working on a Top Secret project.? "Do Not Disturb" cones at his lab door. Last night I had a Nightmare!? I had

Hi all, I put a 4k7 resistor from the drain of Q5 to the +12V rail, and for me, this has resolved the high current draw and low power output on first PTT. I tried about 30 power cycles without noting

JT N1ESE wrote... It would bit of a chore with a soldering iron. I picked up a hot air tool when I got my BITX from http://www.hfsigs.com. It would be pretty easy to heat up several pins at the same

Thanks Buying low cost items from the USA costs me more in postage and VAT @ 20% and ?8 post office service charge to collect the VAT, so turns out not worth it in the long run. BR Andrew

Hi Jan, I have now tested all 5 I have and all of them draw 1.2Amps the moment they are in circuit with TX on, I seem to have bought a fake batch off e-Bay, I have no idea what they even are, I will

Those parts are Prime parts from a US distributor not from eBay or China. I have never had one be bad out of the box, and I have sold 1000's. -- Cecil - k5nwa http://thepartsplace.k5nwa.com/

Oh that MCX connector is nice. Not looking forward to trying to remove the installed SMA connector. N1ESE

Why not using a MCX connector + MCX to BNC pigtail? (See attachments) 73 de Frank PH2M Op 20-10-2017 om 20:41 schreef JT Croteau:

I ran into the same issue. Ended up cutting the end of my pigtail and put a SMA to BNC panel mount connector on the back end of my case and soldering the coax directly to the board. Jesse KJ6JRG

Should work... you could also take a circular file and carve out a little notch in the side of the 80m LPF so it gives some space for the SMA . 73 Hans G0UPL http://qrp-labs.com

Hi Andrew Try the search function of the forum with RD16HHF1 (I think people are forgetting this). Jan

I'm using one and have been very happy with it. I sourced mine from ThePartsPlace from k5nwa; here's their page:?http://www.thepartsplace.k5nwa.com/index.php?route=product/product&product_id=61 (

Hi Hans- Another great kit. I found however:- a) Assume Scematic is correct b) BOM is correct c) Layout and component overlay doesn't agree with schematic, in that R19 and R29 are reversed

Hello JoelAs long as the 'window' of freq correction is 1-5 the signal is stable and clean for long stretches of time...the mean frequency is abt 2-3 Hz lower than a 10 Mhz from a 'real' GPSDO. when