开云体育

I loaded the Beta 002 and the splash screen is still showing 2024. -- 73, Dan - W2DLC

I have also noted the issue that Joel N6ALT reported above.? After loading version 1_01_002 and running the calibration routine, the output level in Digital Modes has dropped roughly in

I don't have attenuators handy and ready, so I disconnected the antenna from my IC-7300 and let it pick up that way.? Might try again through a dummy load, but needless to say, there are issues on

Thank you Eric, and thank you Adam! My housing is printed and I await the fiddly bits!

I made a simple adapter that crosses tip and ring from a jack and a short length of cord and plug so that I can use any several mics I already have. -- 73 KD8CGH

I have had a really good response to this offer to kit together the mics, and with Adam's approval ('cuz it's his mic design) I have ordered more parts so the limit of 9 has as of now been removed. If

Stan, I noticed that while calibrating my QMX+, I had a amplified speaker plugged into it while calibrating, some were only a single tone and some were two tone. Don't know what it all

I ran out of PINK!! Maybe glow in the dark green... :P Erik

I installed Firmware beta 1_01_002 on my high band QMX. In putty I started Optimization and after less then a minute putty became unresponsive. I exited putty and disconnected power from the QMX. I

Chris, I built it for 12V, so that's what I calibrated it at per Hans advice. It seems low in power now, I think the highest power I'm getting is about 1.5 watts, I was getting about 3 watts before.

Erik I just sent money for a microphone. Please pick out a very macho color for me. Address is good in the PayPal or on QRZ. Bill

Well, I finally got it calibrated, not sure what all the numbers meant but it's done. Joel N6ALT

I've done two calibrations and both ran to completion. I was running at less than full power, 10V on a 12V QMX. What voltage were you using?? Did you have a dummy load that gives close to 1:1

Qrpguys has a kit that should work. I ordered one to try it out. https://qrpguys.com/electret-ptt-microphone Dennis KK5DB

Thank you, Erik and Adam both. ?Ordered one and look forward to adding it to my QMX go-kit! -Franz N3HFS

Thanks Adam. I'm just trying to make it easy for more people to enjoy the SSB upgrade.. And you made a great little mic case. Erik

Hey Chris, That is exactly what I'm thinking.? I think, that should work nicely. Thanks for posting the diagram. Cheers. Mel. M0KMD.

You want the version for the (tr)uSDK and uSDX (if you download this now, it will also list the QMX which makes it much easier to pick the correct one). -- Karl Heinz - K5KHK

I am running USB IMD Sync optimization on another QMX - this time I had my headphones plugged in. While it is running the optimization, on some bands I hear the two-tone IMD signal, but on most bands

Hans, I started the calibration process on the original beta .000, about half way through it popped one of the finals and crowbarred my power supply. I changed all 4 mosfets and updated to .002.