开云体育

After a great deal of searching I think I have a conclusion - albeit something I can't rectify. Fault was 0.8R between VDD and 0V. Never tested until construction was complete but have to assume this

I snoozed and lost! ?Thanks for making the connection. ?I need to adjust my notifications!

PIR sensing won’t work. ?“You should know… Don’t wait for me to chase you down.” Need “spouse thoughts band” on next QMX version.

For the fluctuating VSWR reading, did that happen to occur right after hitting a high SWR lockout? ('S' displayed next to the VFO frequency) I've found that that random fluctuation happens both when

Random freeze when transmitting also happened to me exactly once, but with firmware 19. Haven't been able to reproduce it; could have been any number of random interferences or firmware

Ty it helped.

Oooooh we have SPIES among us! 73 Hans G0UPL http://qrp-labs.com https://buymeacoffee.com/g0upl [email protected]> wrote:

You do know us wives are also present in these groups...? we also have our own special groups to spread the word on new fangled fancy dodging tactics... We have eyes everywhere.....

Hi Hans: Bingo! Yep, that worked. Thanks Roger 8P6RX

Hi Dave Ah yes you're right. I didn't think that far ahead. I only have one PIR sensor and planning a location for it. But as you said, we also need to know the incoming speed. So this would require

I'm running my QMX with home made power supplies that replace the SMPS power controllers, these use two TO220 sized linear regulators.? It all works except that I don't have the power on/off

Hans, Now thats what I’m talking about! ?Love the way you think. I’m getting ready and calculating location of the PIR sensor. Some days she can move faster than others! ?I have to factor that

Great that you found out and shared it. But I'm surprised that this standard measure isn't included in the original design. Software hides many hardware problems, but it doesn't fix them. Keyword

Hi Dave Mmmmm, think you can add a sensor that warns me when the wife is heading Not currently, unfortunately. But I think the best way to do this would be wait for when the BASIC scripting language

Hello Chris, My inexpensive DVM shows 11mA at the supply voltage of 11.0V and 21mA at 20.3V. These values may not be very accurate, but the current consumption in the receive mode is very low –

Hi Roger There's a bug report open, that the "tip" and "ring" are reversed on the straight key setting. So for now try "ring" as the straight setting even though you've got a mono plug (means it

Hello from SM Mine drew 12 mA on receive when powered with 12.0 V. My build and test thread pn Mastodon: https://tilde.zone/@raek/112591872225951359 73 DE SA5RJS

I did a nice editing job on the MTL below? but? the rubbish GroupsIO software appeared to lose it. Go by stream of consciousness? I ma NOT going to waste more time on it - the original amp was

Looked for a while and can't seem to find an answer, so here goes: Is it possible send CW directly "live" on the QCX-mini with FLDigi and CAT? I suppose putting the macro string into QCX memory is

Mono plug may be contacting both tip and ring contacts inside the Q? Greg Yahoo Mail: Search, Organize, Conquer On Sat, Aug 3, 2024 at 8:47 PM, Roger Hill<rhill@...> wrote: Should