Hans,
One glitch in the new firmware, 006 and 007 is that Transmit on 60M is about 1450 hz low. Firmware 1_05 works fine, but the 1_06_006 and 007 transmit 1450 hz low. Strange that only this one band has an issue, but I've verified it with receiving on a separate receiver.
toggle quoted message
Show quoted text
Hans,
Thank you very much. Works like it should. Wsjtx requires VFOA to be receive and then with split selected in the setup it turns on split and uses VFOB for transmit.
Using other software like fldigi it also will use VFOB as receive and VFOA for transmitting as it should.?
Very nice and thanks again.
Hi all
I enabled?Split mode in firmware 1_06_006 and it works the same way as on QCX radios. When in Split mode, reception is on VFO A, and transmission is on VFO B.?
Beta?
You can enter split mode by any of the CAT commands:
SP1;
FR2;
FT2;
Please?let me know if this is OK.?
73 Hans G0UPL
On Sat, Nov 26, 2022 at 6:43 PM Mitch Winkle <
ab4mw@...> wrote:
All seems to be working ok for me with 1.06 (newest hardware to date).?
3. Night Mode is welcomed, thank you.
4. Is much easier to quickly verify good TX.? Very nice.??
7. I had worked around the include NULL's, but I'll back that out and test it again.
