I think I have a problem with my QDX: It seems to be hard of hearing. It's not quite deaf, as I can get, just barely, some signal on the lower bands (80, 40). With a dummy load on the QDX, if I transmit at 100mW on a separate TX into a dipole, I can see the signal being received on QDX quite strongly, so it looks like most things are working, but not well.
?
It's a Rev 4 PCB, so it has the C71-C74 mod done prior to being shipped.
?
Transmit seems fine.
?
I've rewound L12 (first time had miscount on turns) and L2 (twisted the 3 wires tighter) and verified all the continuity tests noted in the assembly manual.
?
The self-diagnostic tests seem fine, screenshots included below.
?
But on WSJT-X, the waterfall stays empty. In fact, the noise level doesn't seem to change at all (all bands) with nothing connected to the BNC, vs. a 20m resonant dipole, vs. a 50ohm dummy load.
?
If I put my finger on L12, the noise floor goes up and on occasion I will see a signal that wasn't there before.
?
I'm not sure where to go next. It doesn't feel like the receiver should be this quiet, though.
?
