Hi gang,
I am not planing to cheat Hans on his wonderfull case for the QCX mini, just because I am so penny-wise that I do not buy his tight-fit-far-east creation, but I need a custom enclosure to fit both some LiPos and maybe even a tuner of sorts.
Does anybody have a template for me to drill the front plat knobs? Yes, I could measure them out, but by experience, measured twice, cut thrice and still too short.. am humbly asking for advice.
?
NO! I do NOT intend or even try to drive towards some of those new age crapy 3D prints. I already have a aluminium box that would fit, given the right holes punched trough it's roof. This is where a template would help.
Having the same for QCX+ and the old QCX standart would also help: I have some exemplares built and peacefully living in some chocolate-candy boxes still longing for a case I could punch out of some aluminium scrap if I would know where to put the drill.
Hoping for help! Thanks es 73!
Razvan DL2ARL
DL2ARL