Hi
I am trying to do the 125 MHz calibration of my older kit with the AD9850 module. Software V 3.05 (newer software on order).
This kit had been sitting on the shelf for many years and I just now decided to build the kit.
I am looking at pin 7 of the AD9850 board (next to the GND pin towards the blue pot) with my scope and I am not seeing any waveform. I expect to see a squarewave.
I do not have the GPS, it is also on order.
Do I need to have the Ultimate 3 running in a mode to get a signal?
Any hints?
73,
Randy K7AGE
