Re: QDX - No RF output, Tx line stays low
|
Hi Alan
QDX *is* supposed to be like that and for many people, that's exactly how it is working. I plug in QDX and it "just works"... OK I'm on Linux but many Windows ops have reported success too... The question is: what is different in Windows cases like yours, where it isn't working??
73 Hans G0UPL http://qrp-labs.com
-------- Original message -------- From: Alan G4ZFQ <alan4alan@...> Date: Sun, Nov 14, 2021, 11:10 AM To: [email protected]Subject: Re: [QRPLabs] QDX - No RF output, Tx line stays low On 14/11/2021 07:07, Evan Hand wrote:
> I either get operation as
> normal or the input bar is either high or low red meaning no audio or
> too much audio.? Two more power cycles and it is back to mid-level
> green.?
I have much the same experience.
CAT is lost. Sometimes around 3 startup attempts before it works again
for a while.
Several times on startup or during an attempt to recover from lost CAT I
have seen a giant signal sent to WSJT-X. It is white noise at a very
high level.
I was hoping the QDX would be like a USB sound device and initialise and
startup? when booting Windows but no way.
73 Alan G4ZFQ
|
