Hey Roger Alan and Mike, would it help to shave off some of the other side of the pc board?? Good luck!? Steve KY4GX.
Glory to God in the highest, and on earth peace, good will toward men. Luke 2:14
On Friday, November 5, 2021, 01:16:23 PM EDT, Alan G4ZFQ <alan4alan@...> wrote:
When trying the PCB in the supplied case I find I cannot fit it. There is insufficient clearance for IC7 whatever way or case segment I try. This is the same for the two kits I have. IC6 opposite does begin to enter the slot.
Clearance may be made by machining but why is this so? I could do a photo later but it is obvious if tried (carefully!!)
