Re: Ultimate 3S : generate a tone for 30 seconds, how to ?
|
For the CW tone, you could set the dit time to 30s and simply send the message 'E'. Then you would be able to trim the value to make it go to the next transmission within one second.
The messages can be separated by the delimiter character so the transmissions each get the proper one.
On Mon, Jan 22, 2018 at 11:56 AM, ON4KHG <on4khg@...> wrote: Dear,
Using the Ultimate3S, I'd like to set up a beacon that will generate alternatively Opera05, PI4, JT65, CW and a steady tone for 30 sec or so.
So, I define the ad hoc data (callsign, msg, and so on) for the selected modes and I?enable all these modes. In run mode, after these modes have been running sequentially, I'd like to send a steady CW tone for 30 sec.
I have seen in section 7 of the FW 3.12 documentation that using FSKCW with FSK set to 0 Hz, a steady tone can be sent.
My question is : how the length of that tone can be defined, if it can be defined ?
Otherwise, in general, what would be the way to send a CW tone for x seconds (x could be parametered) in between sequences of other modes ?
Thanks in advance for your help.
73,
Ga?tan, ON4KHG
|
Daniel Ekman SA2KNG