---------- Original Message ----------
From: TrueBlue <44-40@...>
Date: December 28, 2017 at 10:47 PM
On Thu, Dec 28, 2017 at 06:28 pm, Al Holt wrote:
The only glitch or hang-up was the document tells you to use ATmega328 for the MCU
Yeah, I immediately caught that one.? I think most use the 328P; both of my U3Ss do, anyway.? The other confusing part is that it
seems to say that you use a 5-pin ICSP configuration instead of the 6-pin one required for the USBasp, which it also shows.? Naturally, I just converted the blank voltage pin on the U3S to a live 5V as the U3S instructions show, just to accommodate the (useless) USBasp I got.
There's a .TXT file on using the Arduino to program the main chip and it is pretty scary.? This seems straightforward.
When Hans finishes the FT8 firmware update for the U3S I think I'll try to do it this way.
