开云体育

ctrl + shift + ? for shortcuts
© 2025 开云体育
  1. QRPLabs
  2. Messages
Single Messages Topics Expanded Polls

Re: QCX freq/display calibration

 

I would like to say thanks to those who suggested I RTFM.? I just did... Menu 8.5 Ref frq default is 27,004,000.? So once I figured out which way to go I found my actual oscillation is 27,004,750. +/-.? This gets me close enough where both TX/RX freq are just about right on with my Yaesu FT-920.? It may not be 100% but maybe 99%.? I am pleased.? At this point my rig is complete.I just need to figure out what I'm going to do with a case for it.? I am so happy.? I'll be doing my happy dance after my first QSO.??

Now I just wish I can get some quality time on the air when 20m IS open...lol

72;
Kurt - W2MW

-------- Original Message --------
Subject: QCX freq/display calibration
From: Kurt Zimmerman <kurt@...>
Date: Thu, December 07, 2017 7:28 am
To: QRP Labs <[email protected]>

Greetings all;
? So I put my QCX-20 on the air last night to check calibration. I am using my Yaesu FT-920 as my frequency standard. I noticed both TX/RX freq are a few kHz. I don’t recall anything written about calibration other than using the GPS RX to calibrate the XTAL.?

Has anyone else had a calibration issue? I haven’t seen any discussion about this unless I missed something.
72;
Kurt-W2MW?

Get

Join [email protected] to automatically receive all group messages.