Re: Power output on 20 meters.

J68HZ All Messages By This Member #17695 开云体育 That meter is also full spectrum, so measuring all frequencies not just 20M.? Dr.?William J. Schmidt - K9HZ J68HZ 8P6HK ZF2HZ PJ4/K9HZ VP5/K9HZ PJ2/K9HZ ? Owner - Operator Big Signal Ranch – K9ZC Staunton, Illinois ? Owner – Operator Villa Grand Piton - J68HZ Soufriere, St. Lucia W.I. Rent it: email:??bill@... ? toggle quoted message Show quoted text On Nov 2, 2017, at 6:31 AM, Hans Summers <hans.summers@...> wrote: Hi Mike The 9.2 RF Power meter is not bad, but not fantastically accurate. But it is important to realise, this measurement is an RF detector, it will only display a correct power reading for a sinewave into a 50-ohm load. The waveform at L3 is very much NOT a sinewave. The 5.2W measurement is meaningless... 73 Hans G0UPL On Thu, Nov 2, 2017 at 2:23 PM, <mike@...> wrote: Hi All Results on 20M using 9.2 RF test feature...... Output from L1 with 50 ohm load on output = 2.2 watts approx Input to L3 with 50 ohm load on output = 5.2 watts approx Input voltage on load prior to protection diode = 12.13 volts The caps are the correct values, so I am going to change the toroids one by one. 73 Mike G0CVZ

Join [email protected] to automatically receive all group messages.

开云体育