Updated to 1.00b and sidetone problem solved.
I used an arduino uno board programmed as arduino as isp with six jumpers and avrdude. It took a while to work out how to do this I think I'll write it up with some pictures if that helps coz I presume most will want to do the upgrade to 1.00b.
Ive also calibrated using first a nearby receiver to listen for the crystal frequencies and then later using the OLG1 unit. ?There was little difference in results between the two methods but maybe enough to put a wspr transmission outside the band if set close the band edge.
One issue Im seeing is that when the QCX first starts up with the OLG1 connected, the QCX thinks the paddles are closed and so starts sending a series of dit dah dit dah ....... It stops once you enter the menu system or the keyer speed option when pressing the left button. It happens in both practice mode and in non practice mode.
WSPR mode transmission tested and works with a couple of spots from one transmission.
Exploring case options now.
Regards Simon VK3ELH?
