On Sat, May 3, 2025 at 01:47 PM, Jim Bennett / K7TXA wrote:
as far as I can recall, I did not have to do that Volume control push until my QMX rigs were on 1.00.027
Jim, sorry for the delayed response, but I have been offline for a few days.
?
I don't think this issue has anything to do with the specific firmware version; it happens seemingly randomly on some QMX devices.
?
I have 2 QMX and 2 QMX+.? Sometimes the auto-restart into firmware update mode doesn't happen on one of them.? It is as-if the QMX fails to power-up as it resets into firmware update mode.? A press of the power-on button starts it up in firmware update mode, and all proceeds normally.
?
Another similar issue happens sometimes at the end of the firmware update - on one or more of my QMX* devices, the QMX will fail to auto-restart with the new firmware after it is loaded.? I have to remove power, then plug it in and turn it on, and it boots up fine with the new firmware.
?
I have not kept track to see if this happens on the same QMX* device each time or if it is more random - but it is so easy to workaround that I haven't worried about it.
?
Stan KC7XE
