开云体育

Hi everyone,?

I started assembling my Rev4 QDX kit last night that I've been sitting on for years. I got to the step of installing T1, and it seemed to go alright, but when I went to check the continuity as described in the instructions, I found problems. I have good continuity between the ends and center tap of the primary winding and also the ends of the secondary winding. There is no continuity between any of the parts of the primary winding and the secondary winding. There is good continuity between all of the "A" points, and no continuity between any of the "A" and "B" points. However, I am not getting any continuity between the two "B" points. I do get continuity between the ground plane through hole point "B" and the capacitor C17 adjacent to C34 (the other "B" point).?

I tried removing the transformer, re scraping the wire ends and re soldering it, but it still has the same issue. Any suggestions??

Thanks,?

Nate

KV4RD