Bug in firmware beta 1_01_003 display during Tune SWR:
When I choose Hardware tests and then Tune SWR from the QMX menu, the screen shows a frequency, the tune %, the band, and SWR:. Pressing the left button begins the test and shows the measured SWR value.
The Bug is that the frequency shown on this screen is the frequency that my QMX was tuned to before the test, but this is not the frequency that is transmitted for the test, as confirmed by listening for the tuning signal with another radio.
Turning the TUNE knob while this screen is displayed, either before or after starting the test, updates the display to show the actual frequency used for the test, and allows adjustment of that frequency.
This behavior is the same whether the QMX is in CW, Digi, LSB or USB mode. I did not notice this bug before installing the beta firmware, but I cannot be certain that it wasn't there before.
Peter LaRue
AI7YN
