Update: To clarify, I need to "calibrate" ARGO in order to understand where my signal is being transmitted. Any pointers will be appreciated! 73 Brad
toggle quoted message
Show quoted text
--- In QRPLabs@..., "Brad WF7T" <brad.wf7t@...> wrote:
...my version of the QRSS board for 30M. Nice quick build and after a little bit of fiddling with the gimmick capacitor I have a nice 5Hz shift as seen in Argo while transmitting through a dummy load.
Using an IC-7600 through an EDZ for my monitoring setup as I set my final frequency I can actually see my signal (success!) Having only a few minutes of experience with Argo, I am wondering where I want to my signal to show in order to be in that 10.140.00 through 10.140.10 window? Assume I tune my RX rig to 10.140.00 USB.
I do not have a frequency counter handy, so I need to set my final frequency using my rig. I am pretty sure I can get the signal right in there, just having brain problems and will appreciate any pointers on using a rig to adjust my final frequency.
73 Brad WF7T
