I'm very glad you got it working!
I'm very sad it failed again.
When pushing the card into the bottom enclosure, we almost always 'torque' the front panel a bit.? This could cause the connectors to seat differently, or a cold solder joint to open up.? So it may be worth a few tries of repositioning the front panel onto its connectors (if you haven't done that already) to see if the problem will go away.
?
And if you are in the USA and send it to Jeff W1NC, you will get it back and fully operational much faster and cheaper than ordering a pre-built kit.
?
Stan KC7XE
