Cheers Hans.
I've just put in my order for some of the Scientific Wire Company.
(Used them for years, always a good supplier.)
I have plenty of 0.5mm, but the through plating is taking up a little
of the diameter, enough to make life a bit difficult so I'd rather
get a reel in and have it in stock for the future.
73 de Andy G0FTD
--- In QRPLabs@..., Hans Summers <hans.summers@...> wrote:
Hi Andy
The wire is specified as 28AWG (0.37mm). According to the PCB layout
program, the specified drill size for the toroid holes is 0.6mm but I
suppose some thickness is required also for the through-hole plating.
Jun 4, 2013 at 11:34 AM, andyfoad@... <
andyfoad@...> wrote:
**
Can anyone confirm what the wire guage is as used on the LPF's
please ?
I make it either 28 or 30 SWG.
I've stuffed up a few toroids and run out of wire, so I need to be sure
of the guage, especially since the pcb holes are a tight fit with
very little tolerance, but yet I want to use the thickest I can
just to give it whatever (small) extra strength I can for what it's
worth.
73 de Andy G0FTD
