On Fri, Aug 9, 2024 at 09:04 AM, Hans Summers wrote:
Hi John, all
Just loaded 1__00_025 QMX which worked fine initially but now cursors shifted to the left moving only from 10KHz to 10MHz and back as Tune is pressed. Now cannot Tune at all. Did Factory Reset twice and Redownloaded FW to no avail. Guess I need to read manual again. Any thoughts? John
?
I looked into this. It appears that the default tuning rates are set up as 10MHz, 1MHz, 100kHz and 10kHz. It was not my intention, my intention was that defaults should be 1kHz, 500Hz, 100Hz and 10Hz, the same as the available tune rates before they were editable. I have fixed this incorrect default for the next firmware release.?
Coluld qmx have... lets name it 'adaptative tuning speed'? I.E. if the user turns the knob fast then the freq changes with the next higher step...? That way the user would be able to tune across the whole band and then fine-tune without clicking the knob and with just a few rotation of it.?
?
?
