My only concern about using a drill is with multi-layer circuit boards, it might be possible to disconnect the through hole connections.
Dean - KC9REN
toggle quoted message
Show quoted text
On Wed, Jul 10, 2024 at 06:18 AM, David Wilcox K8WPE wrote:
Bill,
?
I have had some criticism for drilling out the left over solder in a through hole opening but I have done it for years (not too many times though). I am just an old Osteopathic family doctor but have used a finger drill and the very fine bits with success. ?I was warned about drilling out the through hole plating but just added a little solder on both sides of the board. ?The few times I had to do that it did work…. So go drill! ?I would like to see what a “half” bit looks like…. Have had one root canal done but wasn't interested in the tools that day. Ha!
Be the REASON someone smiles today.
?
Dave K8WPE
?
