I tried factory reset and f/w017 reload with no change in clicks ?- ?still there. Power cycle or no, any and all changes in settings and it's still the same.?
?
If I turn the volume down to zero or just above, I get no clicks and as I turn up the volume, the clicks just get louder and louder.?
?
*** I think the following is why there is such disparity between different observers: ?If the Side Tone is set To Relative instead of Absolute, then the clicks are much, much less and only become objectionable when the volume is turned up to distorting levels.***
?
I believe it has to do with the tx>rx change over. However, that doesn't quite explain why it is so much worse with Absolute rather than Relative ST volume.
I believe the f/w needs to do what was done in h/w on the QCX. Of course, I am no programmer and I haven't a clue HOW that can be done, but I'm pretty sure it CAN be done. After all, it's been done on many other SDR radios
--
73, Dan? NM3A
There are moments when everything turns out right .... Don't let them alarm you; they pass.?
-Jules Renard
