Larry,
I did the factory reset and reloaded latest
firmware.? No change.
Re did solder on both torids for 10 and 12
meters, no change.
Next step is try and check the diodes as Evan
suggested.
Thank you? 73
Emory? WM3M
On 3/13/2024 7:26 PM, Larry VE7EA
wrote:
toggle quoted message
Show quoted text
Emory: before you go to all the hassle of checking the LPF's I
would definitely try a simple factory reset as Evan suggested
above.
Have you tried that?
The reason I ask is that yesterday I experienced very, very low RF
out on 12 and 10m only. My QMX had been working just fine
previously so I was scratching my head.
Only two things had I done in the meantime between working and
non-working and that was:
1) playing around testing key clicks by turning AGC on and off and
2) I mistakenly tried to tune my IC7300 (10W out) nearby my QMX
while the antenna switch was set to the QMX. This would mean some
SWR and RF at the antenna switch itself (not into the QMX
directly). I think that perhaps the RF caused some glitch in my
QMX, but I cannot be certain.
At any rate, a simple factory reset cured my problem. No idea why!
So try this first...
Larry VE7EA
