I updated to 1_00_017 this morning. I hadn't updated the firmware for about 3 revisions. I went in and configured the display settings to enable Display/controls and enabled Battery: Icon ad Pwr/SWR display On. I noticed that I was not able to send CW. Checked I was not in practice mode, power cycled and still couldn't send CW. Checked and changed out cabling for the keyer and still unable to send CW. I did a factory reset and it all came back. I went back to find out why, and found as soon as I enabled Battery: Icon then I lost the CW again. I left CW off but enabled PWR/Display: On, rebooted and got CW send back, however even though I enabled PWR/Display: On, they do not display for me. Is anyone else having this happen? Not sure what else to do on my end.
72 Scott
KN3A
