QMX observations FW 1_00_017
QMX covers the 80m-20m band, but I don't use the 80m band, so I chose it for the 40m-15m band.
?
1.Setting japanese limits to ENABLED.
When transmitting at 17m and 15m BAND in CW mode, an abnormally large amount of current flows and the BS170 will be damage.
It works normally in Digi mode.?
I think this also happens with QMX Hi-Band Version.
Setting japanese limits to DISABLED makes it works normally.
?
2.In the case of CW mode in system config LSB, the RX frequency and TX frequency differ by 1.40KHz.
The RX frequency is 1.40KHz higher than the displayed frequency.
Normal when using USB in CW mode.
In digi mode, both LSB/USB are normal.
This is the case when CW-R is OFF.
?
When CW-R is ON and USB in CW mode, the RX frequency and TX frequency differ by 1.40KHz.
The RX frequency is 1.40KHz lower than the displayed frequency.?
The CW-R function remains OFF.
When CW-R is ON and LSB in CW mode, RX frequency = TX frequency.?
normal. The CW-R function is turned on.
?
In other words, if you want to? CW-R OFF in CW mode, use USB + CW-R OFF.
When turning CW-R ON in CW mode, it is necessary to use LSB + CW-R ON.
Do not use USB + CW-R ON and LSB + CW-R OFF in CW mode.
?
I would like LSB/USB switching to be enabled only in digi mode, and only CW-R ON/OFF in CW mode.
?
?
syuji ota? ?JH3AQQ
