Re: #qcxmini Can't adjust I-Q Balance, Phase Lo or Phase Hi #qcxmini
|
OK Pat. Then that indicates there is an open trace between the 12v line and the end of R40 that isn’t connected to R39. You can carefully solder a jumper wire between those two locations to bring it up. I would use left over 28 gauge wire from the kit to make the jumper.? Ron On Mon, Feb 12, 2024 at 15:30 Bruce Akhurst <bruce@...> wrote: Start with the end of R40 that isn't connected to R39.? It should have the 'high' voltage used by the PA etc on it . .? ? |
Ronald Taylor