All,
Well now there's a thing.
Rx is now fine - original fault ????
Tx, is FUBAR!
I know why but not why.
In Rx there is a nice signal on the Clk0 & Clk1 lines at the Rx frequency and they are 90 Degrees apart.
On Tx then the frequency on those lines doubles! i.e. if 40M set then 15-ish MHz is seen. They are correctly phased on the gates of the FETs (removed but looks like I didn't need to).
If I run a sweep the Clk0 & Clk1 sweep across the frequency band set but Clk2 is ~2F
That's not right!
A reload of the firmware & factory reset results in the same result!
That explains the sweeps - all well out of range as Clk2 is also 2F not F.
Ideas - Hans?
Regards & thanks for the help
Nick
M0HGU
--
What your soldier wants - really, really wants - is no-one shooting
back at him. (alt.fan.pratchett)
Wed 10984 Sep 16:40:02 BST 1993
16:40:02 up 3 days, 23:37, 8 users, load average: 0.74, 0.38, 0.39
--
73 Nick M0HGU
