It should be simple to add such a jumper to any dummy load, or to make your own dummy load with the jumper.?
Just look at the PCB layout and choose a place to cut.? You mentioned the QRPLabs D/L, but this would be the same task for any of the?usual kit style QRP D/Ls with 20 of 1K resistors. ?
If the D/L has a solid ground plane for positive and a solid ground plane for ground (as I believe the QRPLabs does), you'll have some dremel work to do.? Should be?simple for you to figure out where to cut, given that you had to pass a real ham exam for your ticket.
On Fri, Sep 22, 2023 at 8:55?AM Bryan Curl <bc3910@...> wrote:
Maybe a dumb question, but Is it possible to add a temporary jumper to the qrp labs dummy load in order to make a 100 ohm load?. This would be handy for calibrating an swr meter reflected value. -- regards, Bryan, N0LUF
