UL3S transmits continuously in RUN mode
|
I have just completed building a new Ultimate 3s firmware version v3.12a.? I have install a TCXO and GPS with 1PPS connection only.? The GPS is updating correctly and the frequency is accurate and stable.? ?My intention is to use it as a more stable automated 10 meter CW beacon as a replacement for a converted CB that drifts dramatically with temperature swings but whenever I push the right button at the end of the menu and it goes into run mode, it transmits continuously on the frequency I programmed into it instead of sending CW.? I programmed in the beacon message AC5JM/B AC5JM/B? EM26AR? OK but it just dead keys.? I don't think it is a wiring error because the MPU is able to turn on the transmitter on the programmed frequency when it is in RUN mode and it turns it off when I push the left button to go into setup mode.? I am running in CW mode, but it seems to do the same thing in any mode I operate in.? I searched the groups.io subjects for this problem and so far have been unable to find anyone that has had this same problem.? ?Is there a setting which could cause it to just sit there and transmit continuously?? I apologize in advance if this has been asked 10,000 times before but I have so far been unable to find an answer and reading the manual multiple times has not so far revealed an obvious programming solution.
Thanks, Jerry AC5JM
|
