开云体育

After restoration, I started replacing the double bayonet bulbs with BA15D LED’s. I installed one from WEST MARINE. It was 200 Lumens ; they now have one with 400 lumens. Daryl

Been there done that! Gotta be careful with holding on to those itty bitty screws! Spend almost 20 minutes looking for one that slipped and rolled into never never land. Has anyone replaced the

Yup, our 31, hull #50, had the same head and had been rebuilt more than once. When it also failed to pump from thru hull yet again, we replaced it with a Raritan Super Flush. It barely fit. It

During a few rainy days during commissioning of Intuition this spring, I focused on examining the brass Sea Dog overhead dome lights on my 1990 Vintage PSC 31. What initially looked that sever

Most of our Pacific Seacraft Sailing Vessels have the ubiquitous GROCO HF head/toilet! I have often found that the head will flush when water is dispensed into the bowl, but will not draw water from

I forgot to mention that the ISOTEMP SPA series water heaters come with a 115 volt A/C power cord. I had to install a fiberglass outlet box. The original ATWOOD water heater was wired directly to the

Follow up on the water heater installation: The ISOTEMP SPA 15 fits the galley cabinet very nicely. I did need to install some 1/4 inch starboard spacers under the mounting feet to accommodate

Hey All, Interlude is hull 50 a 1989. She has a Merriman pedestal and two years ago replaced the chain and cables when we had to drop the rudder for some cutless work. Otta be good to go for another

Hello All, For the last 14 years or so, we've been cruising about Maine in our Westsail 43. We love all 40,000 pounds of her, but it's time for us to downsize. I've done a lot of sailing, done the

John, I usually think of rack and pinion steering as more like the Island Packet yachts. I think of the standard EDISON and my MERRIMAN steering pedestal system as chain and wire cable systems. I

John, I have been working on a five year plan since purchasing Intuition, a 1990 PSC 31. #1: take apart your mast step and check for any water intrusion; I would suggest reaming out the mounting

Funny, I assumed that something like steering would have been standard on all PS 31s. I am no expert, but I’m 99% sure that my boat must have the Edson CDi steering system. I have found an Edson

She is a 1988 and has cable and chain. I have owned her since new. And yes it is Edson. Marlena

I have 31 with cable steering. Was not aware that PS used rack and pinion. Marlena

What year is your PSC 31? I know there are few with Rack and Pinion steering; not sure exactly when it was offered! Your PSC owner’s manual should have a section on it, they usually were very good

I noticed that last year Daryl Clark posted a file on Edson steering maintenance. I have two questions that I hoped the group might help with: 1. I am right that this file is talking of cable

WEST MARINE has a 2 for 1 sale on LEWMAR WINCHES (including the lovely bronze winches) purchased a pair of ST16's two years ago, tremendous deal! Daryl s/y Intuition - PSC 31 #54

I made the pilgrimage to the boat last week. The ISOTEMP SPA 15 looks like the best fit! The cabinet opening is 335mm (13.25 inches) wide; 385mm (15") high. The real determining factor though is the

*Found a great web site to check Hull Identification Numbers, just enter your HIN number!* https://www.marinetitle.com/library/hull-identification-number.aspx New Format Mandatory? -? August 1,

Vicki, Any chance you are near your boat? I measured the old Atwood and it's footprint; but did not measure how much further back the water heater could protrude past the original mounting position. I