开云体育

*Planning a future upgrade of the Hitachi alternator to provide SMART CHARGING regulation.* *Wondering what others have done on their PSC 31's.* *Daryl()* *S/Y Intuition - PSC 31 #54*

The Groco HF installed on Intuition is about due for another rebuild! Not able to load water in from thru hull again. Thinking of ditching the current toilet and plumbing and installing an Airhead

I had my motor mounts replaced 3 years ago: they failed this spring due to marina service center installing the wrong ones : (They installed FIRMNESS of 100# front and rear). This caused the

With the assistance of my crew,? I replaced the Harken MK 1 Unit 1 furling system with a *Harken MK IV Unit 1 furling system* : the 32 year old MK 1 had gotten very difficult to furl! The new furling

*Greetings,* I have purchased a *Harken MK IV Unit 1 Furler* to replace the 1 *990 vintage Harken MK 1 Unit 1 furler.* Wondering if anyone has already done this and if so, *did you need additional

Best of luck with the sale of your PSC 31. Looks to be in good condition, at that price i($59,000) t should go fast! I would also advertise in the Cruisers Forum (

https://eastnc.craigslist.org/boa/d/new-bern-pacific-seacraft-31/7481699650.html

One more note on using the West System 610 - it requires temperatures above 50 degrees for at least 24 hours. I had to bring lazarette lid indoors during cure, as outdoor temperatures dropped below

The hinge screws have a washer, lock washer and nut that is encapsulated in the plywood below the skin of the inside fiberglass layer. The inboard screws seem to have the most rot, as they were not

On my 1990 Pacific Seacraft 31, I need to resolve some lazarette hinge mounting screw issues: several screws no longer tighten down properly, due to compression of the nut into the fiberglass

Hi Stu, Have you read your maxprop manual, mine says to turn the engine off in forward while doing a speed of 3-4 knots. Then put it into neutral. You shaft should not spin, or spin very slowly

I have the same set up and I do the same thing. Steve on Rafiki.

Hi All, I have a Yanmar 3YM30 engine with a Kanzaki transmission, and a MaxProp. ?I just want to make sure I am doing the right thing while sailing. ?I have been putting the transmission in reverse

The following files and folders have been uploaded to the Files area of the [email protected] group. * /Rigging and Tuning Information/PSC 31 - Rigging materials worksheet.xlsx (

Greetings, Just received a flyer from West Marine, they have their TWO FOR ONE / BOGO now on Lewmar winches. Just in case anyone is looking for a set of winches. Usually includes the lovely bronze

The width at that point is 18”. I have a Spade anchor. It has worked really well.

What is the width at the 10 inch mark coming aft? Which anchor do you have, is that a MANTUS M1? Daryl Sent: Saturday, January 29, 2022 10:45 AM To:

Thanks! Very much appreciated, as Intuition is 4.5 hours away and probably covered in snow! Daryl Sent: Saturday, January 29, 2022 10:45 AM To: [email protected] Subject:

Hi Daryl, The outside measurement of between stanchions (taken from widest point) is ~ 47”. From front of roller to tip of bowsprit is ~9”. Photos below. Let me know if you wanted measurements

Anyone have measurements for the length of the stainless steel bow pulpit on their PSC 31? Wondering what the outside width measurement is and the measurement from the rollers forward to the forward