开云体育

lol you are asking a lot of what I asked when he braided to redo this. The 165’s are great but the 2555B is better imo. But fitting three in a donor body is a challenge. Ideally I want to do two or

Thanks, I hadn't seen this, or had forgotten, more likely. That looks like a good way to arrange the 3 capsules. Are you upgrading the front cap to the TSB2555 because you feel it sounds better than

THis works great. https://www.instructables.com/Build-the-MS-Alice-Stereo-Microphone/ I am in process of updating it to use a TSB2555B as the main capsule and two TSB165's for the Sides. I built four

I'm thinking about maybe making a mic with 3 capsules to use as a stereo mic for recording instruments in my home studio. So a sort of flexible 2D stereo image mic, rather than a 3D soundfield. I

Hi Charles, You're basically looking for something like the Alice circuit and its many variants, those all do specify which FET to use.? And the FET for the Alice circuits will work for many other

I have several 25mm Chinese electret capsules without internal FETs. How do I add a FET to one to make it like the TSB2590A?? And can I use any FET to do it ?? ? ?Also , In another topic I see an

I’m experimenting with some dynamic mics as budget indoor boom mics for interviews. Typically, the mic for this application would be a hypercardioid/supercardioid SDC with 20-25 mV/Pa sensitivity,

I'm not sure you can make this claim.? I have a somewhat more complex analysis of mike noise in Zephyr.doc ( /g/MicBuilders/files/Mic%20Measurements/Zephyr.doc ) For Gaussian random

Sergio, what mike do you need to increase gain with this device? I have a simple design at /g/MicBuilders/files/Ricardo/ActiveRibbon which probably meets your requirements.? It's

Plase find attached the schematic of my MicBooster. It's not the most perfect in the world, it can always be improved, but it's used by hundreds of discerning users around the world. I had one of

I'm quite the opposite... I managed to squeeze 14 bipolar transistors (packaged in matched pairs), 21 resistors and 5 capacitors into a FetHead-style body. It's a true fully differential amplifier

Remember one thing: the smaller it is, the easier it is to be stolen.

They also have "barrel"

I bought a few samples. There is not much space for the PCB. I don't want to go SMD so I had to give up. The price is quite attractive compared to the Neutrik solution.

That's what I used for my MicBooster. The space is good for conventional through-hole PCB.

Thanks for the suggestions, this gave me the idea to look for other clones, and I found this: GAZ-MA1 MINI Dynamic Microphone Preamp ( https://www.aliexpress.com/item/1005006372538382.html ). It's not

Yuo might even consider using the enclosure of one of these: https://www.aliexpress.com/item/1005006647753658.html It's a sort of Cloudlifter 'clone', and is a robust enclosure - complete with XLRs

KF Flicker noise coefficient 0 AF Flicker noise exponent 1 [email protected]> wrote:

Jan, what is da KF parameter?

There are also these enclosures on Ali: https://pl.aliexpress.com/item/32961610296.html?spm=a2g0n.order_detail.order_detail_item.3.577743cexag7lb&gatewayAdapt=glo2pol Cheap and sturdy. Note, there