开云体育

Rather like removing the transformer from a SM57 then? I have heard about that mod as one that may be good for drums, but I don't actually have a SM57, and maybe I should.

You are of course quite right about the directivity pattern, proximity effect, pressure chamber and flat response issues, however the conclusions you draw from those facts don't match my experience.

I forgot to mention, quite often these capsules are low impedance (about 10-20 ohms) because they are generally paired with transformer, so the output level is lower than a standard SM57, but since

The most prominent feature of the RE20 is its directivity pattern (Variable D), which makes it less prone to proximity (bass boost) effect. BUT. Putting a mic inside a tom completely defeats its

I'm thinking of making or modifying some mics to use for close micing drums in a studio situation. They will often be inside the toms. Criteria, reasonably flat response at least from 50hz to 10k,

Yes. The internal Fet is the same as the TSB2590 so a 100K will work for the resistor vale Best Regards, Jules Ryckebusch

That sounds good Jules! I will wait for that comparison Also thanks to Julian for the JLI-160A advice. I see is built-in FET so I can make a simple P48, right? any advice about this particular capsule

I have some of those. Will be testing them in a side by side recording with the TSB2590 and an orchestra next Thursday Best Regards, Jules Ryckebusch

I’ve tried the JLI-160A11UC680 https://www.jlielectronics.com/microphone-capsules/jli-160a11uc680/ Is like an EM-200 but better, cheaper too, the sound is brighter and the bass more controlled.

I like the EM-200 more than the 204. Check out the TSB2590. Is larger and sounds great. I’m not sure you will find a truly flat cardioid capsule. Best Regards, Jules Ryckebusch

Ok, that have sense. Thanks again ! What about an alternative to Primo EM200/204? I was trying to find some cardioid capsule with such a flat response(or better) but didn't find anything Cheers

Yea, that dotted line is the 180 off axis response Best Regards, Jules Ryckebusch

Dotted graph looks like a frequency response of the back side of the capsule.

Hi all again! :-) I was looking for a Unidirectional / Cardioid capsule for a DIY mic like Primo?EM204 or EM200 with the latest frequency response. Seems EM204 has a slightly better flat response.

Thanks to all for the explanation. I was asking this because I have in mind to get 10 or more AOM-5024L-HD-R. See if I have the luck to find matched capsules and then, make a SASS mic. A few more

Heya Ari! I have a dead TLM103 sitting in my desk. I was going to get Gousheng mail me a dark sounding K47 as replacement but I can wait ;) --- Mateus Borges https://flow.page/mateusaudiofarm Life's

I don't have any suggestions on specifics, but I know a couple of people on the list have some mics that would be good to get some measurements from. My biggest thing (which I'm pretty sure you're all

I'm doing DIY head baskets. Do you have any suggestions on mesh sizes for layered head baskets? Number of weaves, wire thickness etc. What does the 67 use?

Ari, I tried to email you offlist, but gmail thinks I am spam and bounced my message. Could you email me offlist? Thet

Exactly. Phase combination (cancellation as well as enhancement) is what changes the directivity pattern in a multiple capsule arrangement.